Installation And Maintenance Of Anti-corrosion Fan

Install:

1.first check whether the parts are connected firmly, whether the rotation is flexible, whether there is any sundries in the casing.

2.should not forcibly connect the inlet and outlet pipe, the wind pipe weight should not exert on the casing in case of case deforming.

3.Try to dial the impeller, check whether it is flexible, wrong place should be adjusted in time.

4.After the installation is finished, the test operation should be carried out after the parts are normal. In the course of trial operation, the current should be strictly controlled and the rated value should not be exceeded.In order  to prevent the motor from being destroyed by overload, it must be carried out without load when the fan is started and tested. If the situation is good, gradually open the valve to the specified conditions.

 

Maintenance:

1.The fan must be used exclusively for maintenance.

2.Dust in the fan should be cleaned regularly to prevent rusty or imbalance.

3.Switch off before blower maintenance.

4.Except for the replacement of lubricating oil after each repair, the lubricating oil should be replaced in 3-6 months under normal conditions.


Post time: Jun-05-2020